Clean up dirt, debris, and grains inside and outside the machine and rinse with tap water. Remove all the triangular tape and wipe it off. Apply talcum powder, label it, and hang it on the wall inside the library. Then remove the chain, put it down in diesel oil, coat with oil or butter, wrap it in kraft paper and store it in a dry and ventilated place.
Check the consumables on the machine, such as auger telescopic rod sleeves, blades, nails, etc., and find that excessive wear, deformation damage to repair or replace new parts.
The main electrical appliances such as generators and lighting headlamps shall be removed and wiped clean, and the bad ones shall be repaired or replaced and shall be stored separately.
For friction parts, such as cutters, clutch claws, auger extension rods, adjusting bolts, etc., apply oil or butter to prevent corrosion. Painted or rusted parts must be rusted first and then painted again.
Remove the battery and store it separately. Fully discharge the battery. Pour out the electrolyte and rinse it several times with distilled water. After drying, tighten the hole cover and seal the vent hole.
Turn on the water release switch of engine water tank, airframe, and oil cooler, and put clean water; discharge the oil in the fuel tank and oil sump; use plastic cloth to place air cleaner, exhaust nozzle, fuel tank filler, etc. Pack well; inject proper amount of cleaning oil into the cylinder and turn crankshaft several times.
In the end, the combine harvester is lifted by the square wood to move the front and rear tires off the ground; the harvesting table and the puller wheel are lowered to the lowest position, and are placed on the wood stably, so that the hydraulic system does not bear the load. The crankshaft of the engine is rotated twice a month, and the dispensing valve handle is toggled 10-15 times before and after.
Fresh Carrots
Fresh Carrots,Bulk Fresh Carrot,Best New Fresh Carrot,Premium Fresh Organic Carrots
Yirun Agricultural Cooperative , http://www.yiruncn.com