Technical characteristics of
high pressure homogenizer 1. The
high-pressure homogenizer is easy to operate and maintain in design; it can be cleaned with distilled water, pure water and detergent (do not press the pressure switch at this time), or disassemble the pump head for manual cleaning.
2, the machine's start / stop control is located on the side of the machine, easy to operate, can be used for emergency switches, and includes thermal magnetic protection of the main motor.
3. The
high-pressure homogenizer is equipped with a polished stainless steel casing, which is detachable for easy inspection and maintenance. Its base stands on four rubber pads.
4. This machine feeds by self-weight and does not require any feed pump. Only power supply is required without other facilities (such as water or compressed air) 5. According to the sample requirements, gaskets of different materials are used; the standard gasket material is special plastic. The plunger seal uses a special Teflon material that is water lubricated.
5, the refinement is more intense. This is because the valve spool and the valve seat of the working valve are in close contact with each other in the initial position, but only a slit is forcibly extruded by the liquid during operation; and the high speed is satisfied between the rotating stators of the centrifugal emulsification device. Rotating and not generating too much heat, there must be a large gap (relative to the homogenizing valve); at the same time, since the transmission mechanism of the homogenizer is a volumetric reciprocating pump, in theory, the homogenizing pressure can be unlimited The ground is raised, and the higher the pressure, the better the refinement effect.
6. The refinement of the homogenizer mainly utilizes the interaction between the materials, so the calorific value of the material is small, so that the performance of the material can be kept basically unchanged.
7. The homogenizing machine can quantitatively transport the material because it relies on the reciprocating pump to feed.
8. The homogenizer consumes a lot of energy.
9. The homogenizer has more wear and tear, and the maintenance workload is large, especially under high pressure.
10. The
high pressure homogenizer is not suitable for high viscosity conditions.
FROZEN SQUID PRODUCTS
Frozen Squid Products,Frozen Squid,Frozen Calamari Rings,Frozen Squid Woolworths
Zhoushan Fudan Tourism CO., LTD , https://www.fudanfood.com