Using cigarettes to repair locomotives

Cigarettes can be used to diagnose and repair breakdowns in locomotives, and are specially designed for temporary emergency use under conditions of limited or mission-critical emergencies. The method is as follows: First, use the smoke-blowing method to check whether the air vents on the vents, the rear axle housing, the steering gear housing, and the engine crankcase gas check valve (PCV) are unblocked. Perform repairs or replacements. If these components are clogged, the internal pressure will increase, which will easily lead to oil leakage and failure of the relevant parts. The second is to use the smoke-blowing method to check whether the oil passages of the carburetor are open to the carburetor. There are many oil passages and vacuum lines, especially the imported carburetor, which usually needs to be blown with compressed gas after cleaning. But in the end, which oil passages are used? Or the vacuum airway is really blown, and it is very difficult for the operator to make judgments. Therefore, there are many cases of rework. If you use the smoking method, you can easily find out whether each oil or air channel is open. The third is to use the method of blowing smoke to check the tightness of valve and valve seat. Put the ground valve into the valve guide in order, and then use your hand or a suitable tool (such as a screwdriver) to hold the valve, and then smoke a cigarette. The cleaned intake manifold mouth and exhaust manifold mouth are smoked so that the nozzles do not leak under the mouth. At the same time, if there is smoke coming out between the valve and the valve seat, if there is no smoke coming out, it means that the valve seal is good, otherwise it should be reground. Fourth, the use of tobacco shuffling in the middle of the journey if the water tank leakage can use tobacco to temporarily emergency. First, pliers are used to clamp the water fins with large leaking fins, then unscrew the water cover of the water tank, remove the thermostat (to block), knead the tobacco, and put it into the water tank from the water inlet. The engines are operated at low, medium, and high speeds, respectively, so that the shredded tobacco is adsorbed on the leaking water in the tank core. When it is observed that the tank is leaking, cover the filler cap and you can drive. However, it should be noted that this can only be used as an emergency. After returning home, the water tank should be cleaned and thoroughly welded with high-pressure water.

Sex Enhancement Product

Sex Enhancement,Sex Pills,Sex Product

GUANGZHOU XIANGGUO BIO-TECHNOLOGY CO., LTD. , http://www.slimmanufacturer.com